Waeco PerfectView CAM50 Manuel d'instructions télécharger pdf (Page 40)

PerfectView M5L, M7L, M7LX Using the LCD monitor

➤ If necessary, connect the socket C1 (9) of the connection cable to the plug of the vid-

eo source 1 (e. g. camera).

➤ If necessary, connect the socket C2 (10) of the connection cable to the plug of the

video source 2 (e. g. side camera).

➤ M7LX only: If necessary, connect the socket C3 (11) of the connection cable to the

plug of the video source 3 (e. g. reversing camera).

NOTE

Observe the power consumption of the video system. The cameras are

equipped with heaters. A maximum current of 1.5 A can flow (three cameras in

heating mode). Use a disconnector switch for direct connection to the battery.

This allows you to disconnect the video system from the battery easily if you are

no longer using the vehicle.

Connecting an additional reversing camera (trailer operation)

➤ M5L, M7L: If necessary, connect socket C3 (11) of the connection cable to the plug

of the additional reversing camera.

➤ M7LX: If necessary, connect socket C4 (12) of the connection cable to the plug of

the additional reversing camera.

8 Using the LCD monitor

8.1 Switching on the monitor

➤ If the monitor is switched off, press the “P” button (fig. 0 6, page 5) to switch the

monitor on.

✓ The picture appears.

8.2 Switching off the monitor

➤ Press the “P” (fig. 0 6, page 5) button to switch off the monitor.

✓ The picture disappears.

8.3 Adjusting the monitor (fig. 0, page 5)

To set the monitor to suit your requirements, proceed as follows:

➤ Press the “MENU” button (3) to call up the required parameter.

✓ The parameters to be set appear in the following order:

Page 1:

– Brightness: 0 – 60

– Contrast: 0 – 60

– Colour: 0 – 60

_M5L_M7L_M7LX.book Seite 33 Montag, 7. Mai 2012 10:59 10

1 2 ... 35 36 37 38 39 40 41 42 43 44

Pas de commentaire

Waeco PerfectView CAM50 Manuel d'instructions Page 40