Waeco PerfectView CAM50 Manuel d'instructions télécharger pdf (Page 15)

Mounting the camera PerfectView CAM50

8 Mounting the camera

8.1 Tools required

For installation and assembly you will require the following tools:

 Drill bit set (fig. 1 1, page 2)

 Drill (fig. 1 2, page 2)

 Screwdriver (fig. 1 3, page 2)

 Set of ring or open-ended spanners (fig. 1 4, page 2)

 Measuring ruler (fig. 1 5, page 2)

 Hammer (fig. 1 6, page 2)

 Centre punch (fig. 1 7, page 2)

To make and test the electrical connection, the following tools are required:

 Diode test lamp (fig. 1 8, page 2) or voltmeter (fig. 1 9, page 2)

 Insulating tape (fig. 1 11, page 2)

 Cable bushing sleeves, if necessary

To fasten the cables you may require additional cable binders.

8.2 Mounting the camera

CAUTION!

Select a location for the camera and attach it so securely that

it cannot under any circumstances fall off and injure bystanders

(e.g. by being knocked off by branches brushing over the roof of the

vehicle).

NOTE

If installing the camera alters the vehicle height or length specified

in the vehicle documents, your vehicle must be inspected by the

appropriate authorities.

Make sure that you are in possession of documents verifying that

your vehicle has passed this inspection.

_CAM50.book Seite 30 Montag, 7. Mai 2012 3:12 15

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 43 44

Pas de commentaire

Waeco PerfectView CAM50 Manuel d'instructions Page 15