Waeco CF 60 Manuel d'instructions télécharger pdf (Page 34)

Operation

The coolers have an integrated multi-voltage power supply with

priority circuit for connecting to an AC voltage source of 100–240 V.

The priority circuit automatically switches the cooler to mains oper-

ation, if the device is connected to a 100–240 V AC mains, even if

the 12/24 V connection cable is still attached.

When switching between the AC mains and the battery supply,

the red LED may light up briefly.

➤ Plug the 100–240 V connection cable (fig. 1 3, page 3) into

the AC voltage socket and connect it to the 100–240 V AC

voltage mains.

6.4 Using the battery monitor

The device is equipped with a multi-level battery monitor that

protects your vehicle battery against excessive discharging when

the device is connected to the on-board 12/24 V supply.

If the cooler is operated when the vehicle ignition is switched off,

the cooler switches off automatically as soon as the supply voltage

falls below a set level. The cooler will switch back on once the

battery has been recharged to the restart voltage level.

Caution – Danger of damage!

When switched off by the battery monitor, the battery will no longer

be fully charged. Avoid starting repeatedly or operating current

consumers without longer charging phases. Ensure that the battery

is recharged.

In “HIGH” mode, the battery monitor responds faster than at the

levels “LOW” and “MED” (see the following table).

Battery monitor mode LOW MED HIGH

Switch-off voltage at 12 V

10.1 V 11.4 V 11.8 V

Restartvoltage at 12 V

11.1 V 12.2 V 12.6 V

Switch-off voltage at 24 V

21.5 V 24.1 V 24.6 V

Restart voltage at 24 V

23.0 V 25.3 V 26.2 V

_CF-35_60.book Seite 34 Montag, 20. September 2010 10:20 10

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 183 184

Pas de commentaire

Waeco CF 60 Manuel d'instructions Page 34